Plastic cap 25X25 mm, black

A cross with four slots. A 4-way clamp used to attach uprights with 4 horizontal tubes perpendicular to each other. The standpipe passes through the clamp.
Suitable for square tube 25 x 25 mm

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.

Rubber tensioners are available in two sizes.

The distance of the print from the inner frame depends on the diameter of the frame tubes.

For a 20cm rubber band:
Tube 42 mm - Distance 9 cm
Tube 48 mm - Distance 8 cm

Aluminum cap used to plug the end of the tube.

Cover caps are designed to close and finish pipe ends.
These caps are not intended to cover the clamp holes.

Plastic cap used to plug the end of the tube.

Cover caps are designed to close and finish pipe ends.
These caps are not intended to cover the clamp holes.