Road sign clamp 220mm one-sided

Traffic sign post made of hot-dip galvanized steel pipe. Diameter 60mm, length 3500mm.

Tool for tensioning and cutting stainless steel cable ties. Resistant to corrosion and oxidation. Ideally suited for Ball-lock ties made from various grades of stainless steel. The handle can be used to adjust the level of tension on the tie as needed, the built-in mechanism cuts off the excess section of the tie.
The tool is very simple and quick to use.
Suitable for tie 4,6-7,9 mm, thickness 0,4 mm

One-sided traffic sign clip for 76mm pipe

The mounting sleeve is used to quickly install and remove road signs in places exposed to frequent damage, e.g. as a result of traffic accidents, by turning lorries, intentional damage or in places where signage is often changed.

Ground sleeve 48 x 300 mm cast iron, including tensioning nut and PE-clamping ring

Stainless steel band
w: 12 mm t: 0,6 mm l: 30 m

When a vehicle collides with a road sign post, which is equipped with a spring, the road sign restores its upright position.
Suitable for traffic poles up to 2,7m long and Ø60mm in diameter
Tested: 70 km/h
Recommended areas of use: parking lots, separation islands, tramways, ring roads, etc.