Steel ground sleeve 48 x 500mm

Adhesive sign-masking-tape for short-term invalidation of traffic signs
In the presentation black / bright orange / black for use during the day
– size: 75mm x 33 m
– orange-black print
– non-reflective

Adapter is perfectly suited for a quick installation of traffic signs.

Tool for tensioning and cutting stainless steel cable ties. Resistant to corrosion and oxidation. Ideally suited for Ball-lock ties made from various grades of stainless steel. The handle can be used to adjust the level of tension on the tie as needed, the built-in mechanism cuts off the excess section of the tie.
The tool is very simple and quick to use.
Suitable for tie 4,6-7,9 mm, thickness 0,4 mm

Ball-lock cable ties made of AISI 304 stainless steel, 201 provide excellent resistance to high temperatures, corrosion and extraordinary resistance to UV radiation. These cable ties are very easy to install.
EXAMPLE USE:
• fixing of cables and pipes in shipbuilding, petrochemical plants, offshore platforms and fire risk environments
• „electrical safety” markings in identification label installation (e.g. fire extinguishing system) which must be maintained in the event of fire
• installations where high mechanical and UV resistance is required

Tie width 7,9mm
Tie thickness 0,4mm
Tie lenght 600 mm

The mounting sleeve is used to quickly install and remove road signs in places exposed to frequent damage, e.g. as a result of traffic accidents, by turning lorries, intentional damage or in places where signage is often changed.

Ground sleeve 48 x 300 mm cast iron, including tensioning nut and PE-clamping ring

When a vehicle collides with a road sign post, which is equipped with a spring, the road sign restores its upright position.
Suitable for traffic poles up to 2,7m long and Ø60mm in diameter
Tested: 70 km/h
Recommended areas of use: parking lots, separation islands, tramways, ring roads, etc.