Type 126, Angle Cross 0°- 45° Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Add-on Short Tee. Forms a perpendicular connection between two tubes. Used for expanding and adapting existing structures.

Long Slope Tee - Variable angle 0° - 11°. Similar to Type 2SE. This fitting can be used where a join is required in the horizontal tube.

Side Palm. Side-mounting fitting for vertical post. The upright cannot pass through the fitting.

Adjustable Short Variable angle 45° - 60°. This adjustable angle clamp is used to join tubes between 45° and 60°. Use for diagonal braces, struts and an angled top rail joint to vertical posts on stairs.

Openable Short Tee 45°. Forms a connection between two tubes at an angle of 45°.