Type 251, Slope Base Flange (30°- 45°) Ø48.3 mm
SKU: NKL251E
Unit: pc
Qty: In Stock
Delivery time: 1-2 nädalat
Unit: pc
Qty: In Stock
Delivery time: 1-2 nädalat
Price:
22,38 €
price inc. tax 27,30 €
Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.
Similar products
Railing Base Flange. Strong baseplate to support vertical post. Vertical wide rib with two setscrews increases the strength of the clamp. The fixing holes in the base flange should be in line with the applied load.
SKU: NKL012E
, Qty: In Stock
, Delivery time: 1-2 nädalat
17,55 €
Galv. Heavy Duty Side Palm. Extra heavy fascia attachment for vertical posts. This clamp is not suitable for continuous tubes. Intended for the manual attachment of safety rails and balustrades to the walls, parapets, stairs and ramps with flat mounting.
SKU: NKL146E
, Qty: Out of Stock
, Delivery time: 1-2 nädalat
22,00 €
Three Way Top Corner. Corner joint (90°) clamp used for top rail corners and any other rectangular system.
SKU: NKL018E
, Qty: In Stock
, Delivery time: 1-2 nädalat
14,40 €
Corner With Trough Tube 90°. Often used on intermediate rail corners to match Type 18, tube passes through the clamp.
SKU: NKL020E
, Qty: In Stock
, Delivery time: 1-2 nädalat
11,83 €
Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.
SKU: NKL028E
, Qty: In Stock
, Delivery time: 1-2 nädalat
7,88 €
Galv. Eves Fittings 27½°. This tube fitting is used for roof construction and is usually in combination with type 91.
SKU: NKL085E
, Qty: In Stock
, Delivery time: 1-2 nädalat
24,65 €
