Type 310, Add-on Short Tee Ø48,3

Base flange for sloping sites, adjustable from 11° to 29°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design.

Galv. Heavy Duty Side Palm. Extra heavy fascia attachment for vertical posts. This clamp is not suitable for continuous tubes. Intended for the manual attachment of safety rails and balustrades to the walls, parapets, stairs and ramps with flat mounting.

Adjustable Knee Piece. Variable elbow fitting. This tubefitting can make a minimum angle of 75 degrees to a maximum of 210 degrees.

Single Swivel. Swivel fitting for variable angle fixing.

Long Slope Tee - Variable angle 0° - 11°. Similar to Type 2SE. This fitting can be used where a join is required in the horizontal tube.

Internal Coupling. A streamlined flush joint in two tubes of the same size. Wall thickness must be 3.2 mm. Do not apply direct loads to this joint.