Type 3381,Glass holder Ø 33,7 mm untreaded

Double body pipe fitting with three outlets and two 90° angles for connecting pipes. The continuous pipe and the end of the pipe are connected to the T by this pipe fitting, fixing the two halves. Finish: untreaded aluminum

Single body four outlet pipe fitting for connecting three pipes with five 90° elbows. The continuous pipe and the two pipe ends are connected to this pipe joint at the corner. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The split base bearing is tightly fixed around the pipe by tightening the two screws and the sleeve nut. The screw and the sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for vertically attaching a pipe to a surface. The pipe connector has a base plate with two holes for fastening. The pipe end is fixed in the pipe connector with a grub screw. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The pipe is drilled twice with a diameter of 9.5mm. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single body pipe fitting with single pipe end outlet. This clamp can be combined with clamp 3316 to form a T or a cross. The pipe is fixed in the pipe fitting with a screw. Finish: untreaded aluminum