Type 51, Swivel Base Ø48,3

Add-on Side Outlet Tee. The same tube fitting as type 24, but this tube fitting can be placed on an existing construction by means of a foldable part on the vertical tube connector.

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Slope Railing Base - variable angle 0° - 11°. Base fitting for railings designed on slopes up to 11°.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø60.3 and vertical Ø48.3mm.

Clamp-On Crossover. 90° crossover joint fitting for adding to an existing structure.

Designed to attach a freestanding handrail to an upright post on a variable angle.

The 752 Interclamp fitting is designed for intermediate support of horizontal galvanised handrail tubes where no joining of the tubes are required. They are also used when fitting the 724 Assist handrail end termination to the upright post.