Type 63, Pin Hinge Ø48,3

Base flange for sloping sites, adjustable from 11° to 29°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design.

Adjustable Knee Piece. Variable elbow fitting. This tubefitting can make a minimum angle of 75 degrees to a maximum of 210 degrees.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø60.3 and vertical Ø48.3mm.

Single Swivel. Swivel fitting for variable angle fixing.

Collar. Support fitting to increase the slip resistance of fittings that are under high loads.

Internal Coupling. A streamlined flush joint in two tubes of the same size. Wall thickness must be 3.2 mm. Do not apply direct loads to this joint.