25x25mm

Short T-piece - 25 mm. Forms a perpendicular connection between two tubes. Upper fitting for straight, horizontal railing supports. This fitting can not be used for horizontal tube connections in the fitting itself.

Long T-piece. This fitting can be used where a join is required in the horizontal tube.

Slope Elbow 90° Variable angle 0° - 11°. Elbow joint fitting used as an end fitting for the top rail up to 11°.

Straight Coupling. Joint clamp for tubes of the same diameter. Do not use for heavy vertical loads. Alternative clamp is Type 9 used as an internal spigot.

Square footplate - 25 mm. Use this clamp for positioning constructions. Do not use as a basis for supporting safety railings and the like.

Three-way elbow 90° - 25 mm. Angle connection clamp (90°) for corners of overheads and all other angled connections.

Angle of continuous upright - 25 mm. Corner connection (90°), where the vertical tube runs through the clamp.

Two Socket Cross - 25 mm. 90°- joint clamp between the middle rail and an upright on railings.

Side Outlet Tee - 25 mm. 3-direction clamp used to fix uprights with 3 horizontal tubes that are perpendicular to each other. The upright tube passes through the clamp.

A cross with four slots. A 4-way clamp used to attach uprights with 4 horizontal tubes perpendicular to each other. The standpipe passes through the clamp.
Suitable for square tube 25 x 25 mm

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.

Type 34, Handrail support - 25 mm. To attach railings and constructions to walls.

Male Single Lug. Also used for fixing panels and boards.
Suitable for square tube 25 x 25 mm

Type 55, Eyelet part single lip - 25 mm. Tubefitting for fixing panels.

Collar plate double sided lip - 25 mm. Tubefitting for fixing panels.
Suitable for square tube 25 x 25 mm

Collar Plate Double Side 90°. Panel fixing with two lugs also used for locking gates.

Hook twisted - 25 mm. Suited for making coat hangers and the like.
Suitable for square tube 25 x 25 mm

Steel galvanized square 25x25 mm tube profile / socket of 2 mm thickness.
This profile has a standard trade length of 6 meters, but can always be cut to size for you.
Suitable for our square tubefittings.

The advantage of black color is that the color goes very deep into the material, which prevents the pipe from corroding too quickly.
The black tubes are also suitable for outdoor use, but it must be taken into account that the color is not resistant to UV radiation, and long-term exposure of the product to outdoor conditions will cause the color to fade.

Maximum length for shipping with couriers is 2 meters!

Plastic cap for tube 25X25 mm
black
Cover caps are designed to close and finish pipe ends.
These caps are not intended to cover the clamp holes.

Steel galvanized square 25x25 mm tube profile / socket of 2 mm thickness.
This profile has a standard trade length of 6 meters, but can always be cut to size for you.
Suitable for our square tubefittings.
Maximum length for shipping by courier 2m!